rfx - Vitec/Connectware/AP&D RasterFlex framebuffer series
rfx* at sbus? slot ? offset ?
wsdisplay* at rfx?
The RasterFlex series, originally manufactured by Vitec,
later bought by
Connectware, then by Advanced Products & Design, are highperformance
frame buffers and frame grabber devices.
The rfx driver only supports the RasterFlex frame buffers:
RasterFlex-24
RasterFlex-32
RasterFlex-HR
The rfx driver interfaces the frame buffer with the wscons(4) console
framework. It does not provide direct device driver entry
points but
makes its functions available via the internal wsdisplay(4)
interface.
The RasterFlex frame buffers will adapt their resolution to
the monitor
they are connected to. However, when not connected to a Sun
monitor, the
device will default to the 1152x900 resolution, with a refresh rate of
66Hz. A different resolution can be forced using the
jumpers J2 to J4,
located near the video connector on the board itself.
In the following tables, left (L) and right (R) Jumper positions are described
looking at the board with the video connector on
top. If the
jumper position is not specified, it means it has to be removed (open).
RasterFlex-24 and RasterFlex-32 Jumper Settings:
J2 J3 J4 Resolution Refresh Description
R R R 1152x900 66Hz Automatic Configuration
L L L 1024x768 76Hz SVGA
L 1152x900 66Hz
L L 1152x900 76Hz
RasterFlex-HR Jumper Settings:
J2 J3 J4 Resolution Refresh Description
R R R 1152x900 66Hz Automatic Configuration
L L L 1024x768 76Hz SVGA
L 1152x900 66Hz
L L 1152x900 76Hz
L 1280x1024 60Hz
L L 1280x1024 67Hz
L L 1280x1024 76Hz
agten(4), bwtwo(4), cgsix(4), cgthree(4), creator(4), intro(4), mgx(4),
sbus(4), vgafb(4), wscons(4), wsdisplay(4), zx(4)
This driver does not support any acceleration features at
the moment, and
drives the card in PROM-compatible, 8 bit, mode only.
OpenBSD 3.6 June 20, 2004
[ Back ] |