kill - send signal to a process
kill(pid_t pid, int sig);
The kill() function sends the signal given by sig to pid, a
process or a
group of processes. sig may be one of the signals specified
sigaction(2) or it may be 0, in which case error checking is
but no signal is actually sent. This can be used to check
For a process to have permission to send a signal to a process designated
by pid, the real or effective user ID of the receiving process must match
that of the sending process or the user must have appropriate privileges
(such as given by a set-user-ID program or the user is the
single exception is the signal SIGCONT, which may always be
sent to any
descendant of the current process.
If pid is greater than zero:
sig is sent to the process whose ID is equal to pid.
If pid is zero:
sig is sent to all processes whose group ID is equal
to the process
group ID of the sender, and for which the process has permission;
this is a variant of killpg(3).
If pid is -1:
If the user has superuser privileges, the signal is
sent to all
processes excluding system processes and the process
signal. If the user is not the superuser, the signal is sent to
all processes with the same uid as the user excluding the process
sending the signal. No error is returned if any
process could be
Setuid and setgid processes are dealt with slightly differently. For the
non-root user, to prevent attacks against such processes,
some signal deliveries
are not permitted and return the error EPERM. The
signals are allowed through to this class of processes:
SIGTERM, SIGSTOP, SIGTTIN, SIGTTOU, SIGTSTP, SIGHUP, SIGUSR1, SIGUSR2.
For compatibility with System V, if the process number is
not -1, the signal is sent to all processes whose process
group ID is
equal to the absolute value of the process number. This is
a variant of
Upon successful completion, a value of 0 is returned. Otherwise, a value
of -1 is returned and errno is set to indicate the error.
kill() will fail and no signal will be sent if:
[EINVAL] sig is not a valid signal number.
[ESRCH] No process can be found corresponding to that
[ESRCH] The process ID was given as 0 but the sending
not have a process group.
[EPERM] The sending process is not the superuser and
user ID does not match the effective user ID
of the receiving
process. When signaling a process group,
this error is
returned if any members of the group could not
getpgrp(2), getpid(2), sigaction(2), killpg(3), raise(3)
The kill() function is expected to conform to IEEE Std
OpenBSD 3.6 April 19, 1994
[ Back ]