iic -- I2C generic i/o device driver
The iic character device driver provides generic i/o to any iicbus(4)
instance. In order to control I2C devices, use /dev/iic? with the following
I2CSTART send start condition to the specified device (with 7-bit
address) on the bus
I2CSTOP send stop condition to the bus
I2CRSTCARD reset the bus
You may also use read/write routines, then I2C start/stop handshake is
managed by the iicbus system.
The iic manual page first appeared in FreeBSD 3.0.
This manual page was written by Nicolas Souchu.
FreeBSD 5.2.1 October 25, 1998 FreeBSD 5.2.1 [ Back ]