fpa, fea -- device drivers for DEC FDDI controllers
The fpa and fea device driver provides support for the DEC DEFPA PCI FDDI
Controller and the DEC DEFEA EISA FDDI Controller, respectively. All
variants of either controller are supported including the DAS and SAS
fea%d: error: desired IRQ of %d does not match device's actual IRQ (%d)
The device probe detected that the DEFEA board is configured for a different
interrupt than the one specified in the kernel configuration file.
fea%d: error: memory not enabled! ECU reconfiguration required The
device probe found that no device memory had been configured on the
DEFEA. Also the DEFEA can be configured with no device memory, this
driver requires a minimum of 1K device memory be setup. The ECU (EISA
Configuration Utility) will need to be run to change the settings.
Normally, the device driver will not enable the reception of SMT frames.
However if the IFF_LINK1 flag is set, the device driver will enable the
reception of SMT frames and pass them up to the Berkeley Packet Filter
arp(4), netintro(4), ifconfig(8)
The fpa and fea device driver and manual page was written by Matt Thomas.
FreeBSD 5.2.1 March 13, 1995 FreeBSD 5.2.1 [ Back ]