fpa, fea - DEC FDDI controller device driver
fpa* at pci? dev ? function ?
fea* at eisa?
The fpa and fea device drivers provide support for the DEC
DEFPA PCI FDDI
Controller and the DEC DEFEA EISA FDDI Controller, respectively. All
variants of either controller are supported including the
DAS and SAS
fea%d: error: desired IRQ of %d does not match device's
(%d) The device probe detected that the DEFEA board is configured for a
different interrupt than the one specified in the kernel
fea%d: error: memory not enabled! ECU reconfiguration
required The device
probe found that no device memory had been configured
on the DEFEA.
The DEFEA can be configured with no device memory, this
driver requires a
minimum of 1K device memory be set up. The ECU (EISA Configuration Utility)
will need to be run to change the settings.
arp(4), eisa(4), intro(4), netintro(4), pci(4), ifconfig(8)
The fpa and fea device driver and manual page were written
Normally, the device driver will not enable the reception of
However if the IFF_LINK1 flag is set, the device driver will
reception of SMT frames and pass them up to the Berkeley
OpenBSD 3.6 March 13, 1995
[ Back ]