dpt - DPT EATA SCSI RAID adapter driver
dpt* at eisa? slot ?
dpt* at pci? dev ? function ?
scsibus* at dpt?
The dpt driver provides support for the following SCSI
DPT SmartCache III
DPT SmartCache IV
DPT SmartRAID III
DPT SmartRAID IV
None of these messages should be encountered under normal
It should be noted that the list below is not complete.
dpt0: readcfg failed - see dpt(4) The EATA configuration
data did not
appear upon request. This may be caused by older firmware.
the solution is to power-cycle the affected machine.
dpt0: spurious intr A spurious interrupt was received from
dpt0: bogus status (returned CCB id NNNN) A corrupt or incomplete status
packet was received from the HBA.
cd(4), ch(4), eisa(4), intro(4), pci(4), scsi(4), sd(4),
This manpage is inadequate.
The dpt driver first appeared in OpenBSD 2.5.
The dpt driver was written by Andy Doran <firstname.lastname@example.org>,
based upon the
uha and bha drivers, which are the work of others.
The first (0th) and subsequent (for multi-channel cards) scsibus(4)
should be attached at the dpt, because of the way the driver
and OpenBSD scsi(4) layer design limitations.
EATA adapters other than listed may function correctly with
the dpt driver,
however a definitive list is not available.
Older firmware may prove problematic. It is recommended
that the latest
available firmware be used. Contact DPT for a firmware update.
Older boards that do not support scatter-gather I/O or DMA
are not supported.
An ISA front-end is needed.
ECC formatted disk and arrays (i.e., with a sector size of
528 bytes) do
not work correctly with the PM2041 and certain firmware revisions of the
OpenBSD 3.6 September 28, 1999
[ Back ]