cue - CATC USB-EL1201A USB Ethernet driver
cue* at uhub? port ?
The cue driver provides support for USB Ethernet adapters
based on the
Computer Access Technology Corporation's USB-EL1202A
chipset. This includes
the following adapters:
CATC Netmate II
The USB-EL1202A supports a 512-bit multicast hash filter,
filter entry for the station address and promiscuous mode.
received and transmitted over separate USB bulk transfer
The CATC adapter supports only 10Mbps half-duplex mode,
hence there are
no ifmedia(4) modes to select.
For more information on configuring this device, see ifconfig(8).
cue%d: watchdog timeout A packet was queued for transmission and a
transmit command was issued, however the device failed to
transmission before a timeout expired.
cue%d: no memory for rx list The driver failed to allocate
an mbuf for
the receiver ring.
arp(4), intro(4), netintro(4), usb(4), hostname.if(5), ifconfig(8)
The cue device driver first appeared in FreeBSD 4.0. OpenBSD support was
added in OpenBSD 2.7.
The cue driver was written by Bill Paul
<email@example.com> and ported
to OpenBSD by
Aaron Campbell <firstname.lastname@example.org>.
OpenBSD 3.6 January 13, 2000
[ Back ]