ivcat - concatenates and converts Inventor files
ivcat [-bfht] [-o file] [file ...]
ivcat reads each file in sequence and then writes each out. If no input
file is given, or a filename of "-" is specified, ivcat reads from the
standard input file. The input files must be valid Open Inventor 3D
Interchange Format files (1.0 or 2.0).
The following command line options are allowed:
-b Write out the files in binary Inventor format. The default is to
write out the files in Inventor's ASCII format.
-f Remove all SoFile nodes. This has the effect of condensing
hierarchical files into a single file.
-h Print usage message.
Send the output to the given file, instead of to the standard
-t Expand SoTexture2 nodes to explictly include the texture data rather
than a file name.
To convert from binary to ASCII Inventor
ivcat < binaryfile.iv > asciifile.iv
To convert from ASCII to binary Inventor:
ivcat -b < asciifile.iv > binaryfile.iv
Note that the source code to ivcat comes with the Open Inventor 3d
/usr/share/data/models/* - Sample Inventor data files
/usr/share/src/Inventor/tools/ivcat/* - Source to ivcat
inventor, ivview, noodle, SceneViewer, gview
Page 1 Release 6.5 August 1991 [ Back ]