NAME [Toc] [Back]
tirdwr - STREAMS module for reads and writes by Transport Interface
DESCRIPTION [Toc] [Back]
The tirdwr module is a STREAMS module that provides a transport user
supporting the Transport Interface (TI) with an alternate interface to
a transport protocol provider supporting TI. This alternate interface
allows the transport user to communicate with the transport protocol
provider using the read() and write() functions. It can also continue
to use the putmsg() and getmsg() functions, but these functions will
only transfer data messages between the user process and device
stream. getpmsg() and putpmsg() should not be used with tirdwr.
The user places the tirdwr module on a device stream by calling the
STREAMS I_PUSH ioctl() function. tirdwr is an alternative interface
to timod(7). If timod has been pushed onto the stream, the user
should use the I_POP ioctl to remove the timod module from the stream
before pushing tirdwr. The tirdwr module should only be pushed onto
streams which are terminated by transport providers which conform to
the Transport Interface. Once the module has been pushed on the
device stream the user cannot make further calls to TI functions. If
the user attempts to do this, an error occurs on the stream. After
the error is detected, subsequent calls fail with errno set to
[EPROTO]. The user removes the tirdwr module from a device stream by
calling the STREAMS I_POP ioctl() function.
Module Behavior When Pushed and Popped [Toc] [Back]
When the tirdwr module is pushed on a device stream, it checks any
existing messages that are destined for the user to determine their
message type. If existing messages are regular data messages, it
forwards the messages to the user. It ignores any messages related to
process management, such as messages that generate signals to the
user. If any other messages are present, it returns an error to the
user request with errno set to [EPROTO].
When the tirdwr module is popped from a device stream, it checks
whether an orderly release indication has been previously received
from the transport protocol provider. If an orderly release
indication was received, it sends an orderly release request to the
remote side of the transport connection. The tirdwr module also acts
this way when the device stream is closed.
Module Behavior for Reads and Writes [Toc] [Back]
When the tirdwr module receives messages from the transport protocol
provider that do not contain a control part (see the putmsg(2) and
getmsg(2) reference pages), it transparently passes the messages to
its upstream neighbor. The exception is for zero-length data
messages, where the module frees the message and does not pass them to
its upstream neighbor.
Hewlett-Packard Company - 1 - HP-UX 11i Version 2: August 2003
When the module receives messages from the transport protocol provider
that contain a control part, it takes one of the following actions:
For data messages with a control part, it removes this part, then
passes the message to its upstream neighbor.
For messages that represent expedited data, it generates an
error. Further system calls will fail with errno set to
For messages that represent an orderly release indication from
the transport protocol provider, it generates a zero-length data
message, indicating the End-of-File (EOF), and sends this message
upstream to the reading process. The original message containing
the orderly release indication is freed.
For messages that represent an abortive disconnect indication
from the transport protocol provider, it causes all further
write() and putmsg() calls to fail with errno set to [ENXIO].
Subsequent read() and getmsg() calls will return zero-length data
messages indicating the End-of-File (EOF), once all previous data
has been read.
For all other messages, it generates an error, and further calls
will fail with errno set to [EPROTO].
SEE ALSO [Toc] [Back]
getmsg(2), putmsg(2), read(2), write(2), t_open(3), streamio(7),
Hewlett-Packard Company - 2 - HP-UX 11i Version 2: August 2003 [ Back ]