ex -- Ethernet device driver for the Intel EtherExpress Pro/10 and
The ex driver provides support for the 16-bit PCI Intel EtherExpress
Pro/10 and Pro/10+ Ethernet cards based on the Intel i82595 chip. The
Olicom OC2220 is also supported.
The card will be searched for in the I/O address range 0x200 - 0x3a0. If
the IRQ will be read from the EEPROM on the card. For correct operation
on newer cards the Plug-N-Play support should be disabled.
ex%d: Intel EtherExpress Pro/10, address %6D, connector %s The device
probe found an installed card, and was able to correctly install the
ex%d: WARNING: board's EEPROM is configured for IRQ %d, using %d The
device probe detected that the board is configured for a different interrupt
than the one specified in the kernel configuration file.
ex%d: invalid IRQ. The device probe detected an invalid IRQ setting.
Currently the driver does not support multicast.
arp(4), netintro(4), ng_ether(4), ifconfig(8)
The ex device driver first appeared in FreeBSD 2.2.
The ex device driver was written by Javier Martin Rueda. This manual
page was written by David E. O'Brien.
FreeBSD 5.2.1 January 19, 1997 FreeBSD 5.2.1 [ Back ]